Chapter 3: Using the Web Interface
84
d.
Select Gateway or Interface from the drop-down and provide the following additional information:
If you select Gateway, enter a gateway address in the adjacent text box.
If you select Interface, select from BRIDGE, ETH1, ETH2, and WIRELESS options in the adjacent drop-down
field.
e.
Use the
and
buttons to arrange the order of the routes.
f.
Click
to delete a created route.
5.
Configure IPv6 Route settings as follows:
a.
In the Default Gateway text box, provide a default gateway address for your IPv6 routes.
b.
Click Add Route.
c.
In the Destination text box, enter a valid destination address.
d.
Select Gateway or Interface from the drop-down and provide the following additional information:
If you select Gateway, enter a gateway address in the adjacent text box.
If you select Interface, select from BRIDGE, ETH1, ETH2, and WIRELESS options in the adjacent drop-down
field.
e.
Use the
and
buttons to arrange the order of the routes.
f.
Click
to delete a created route.
Ethernet Interface Settings
By default the ETH1/ETH2 interfaces for your PDU are enabled.
Ethernet interface settings:
1.
Select Device Settings > Network.
The Network page appears.
2.
Click the ETH1 or ETH2 title bar as shown.
Note: ETH1 and ETH2 sections of the Network page have the same configuration settings available for each port.
Therefore, they are covered in this single topic for the sake of space.