Chapter 3: Using the Web Interface
59
3.
Select "managed" sensors/actuators. See Sensor/Dry Contact States (on page 63).
4.
Click
> Release.
5.
Now released sensors/actuators become "unmanaged."
Managing One Sensor or Dry Contact
If you are managing only one sensor or dry contact, you can assign the desired ID number to it. Note that you cannot
assign ID numbers when you are managing multiple sensors/dry contacts at a time.
Tip: When the total of managed sensors/dry contacts reaches the maximum (32), you cannot manage additional ones. The
only way to manage any sensor/dry contact is to release or replace any managed ones. To replace a managed one, assign
an ID number to it by following this procedure. To release any one, see Peripherals (on page 56).
To manage only one sensor/dry contact:
1.
Click Peripherals.
2.
From the list of "unmanaged" sensors/dry contacts, click the one you want to manage.
The "Manage peripheral device" dialog appears.
