Chapter 3: Using the Web Interface
145
To create a switch peripheral dry contact action:
1.
Choose Device Settings > Event Rules >
.
2.
Select "Switch peripheral actuator" from the Action list.
3.
In the Operation field, select an operation for the selected actuator(s).
4.
Turn On: Turns on the selected actuator(s).
5.
Turn Off: Turns off the selected actuator(s).
6.
To select the actuator(s) where this action will be applied, select them one by one from the Available Actuators list.
7.
To add all actuators, click Select All.
8.
To remove any selected actuator from the Selected Actuators field, click that actuator's
.
9.
To remove all actuators, click Deselect All.
10.
Click Create.
Syslog Message
Use this action to automatically forward event messages to the specified syslog server. Determine the syslog transmission
mechanism you prefer when setting it up - UDP, TCP or TLS over TCP.
The PDU may or may not detect the syslog message transmission failure. If yes, it will log this syslog failure as well as the
failure reason in the event log. See
Viewing or Clearing the Local Event Log
To create a syslog message action:
1.
Choose Device Settings > Event Rules >
.