Chapter 3: Using the Web Interface
144
2.
Select "Switch outlets" from the Action list.
3.
In the Operation field, select an operation for the selected outlet(s).
4.
Turn Outlet On: Turns on the selected outlet(s).
5.
Turn Outlet Off: Turns off the selected outlet(s).
6.
Cycle Outlet: Cycles power to the selected outlet(s).
7.
To specify the outlet(s) where this action will be applied, select them one by one from the Available Outlets list.
8.
To add all outlets, click Select All.
9.
To remove any outlets from the Selected Outlets field, click that outlet's
.
10.
To remove all outlets, click Deselect All.
11.
If "Turn Outlet On" or "Cycle Outlet" is selected in step 3, you can choose to select the "Use sequence order and
delays" checkbox so that all selected outlets will follow the power-on sequence defined on the page of
Switch Peripheral Dry Contact
If you have any dry contact connected to the PDU, it can be configured so it automatically turns on or off the system
controlled by the dry contact when a specific event occurs.
Note: For information on connecting dry contacts, refer to Contact Closure Sensor Series in the PDU with
RackLink Environmental Sensors User Manual at
www.middleatlantic.com/resources/power-downloads.aspx