Microtronics myDatalogNANOamr, Руководство пользователя, Страница: 18 / 125

Note: These operating instructions are part of the device and must be available to the user at
all times. The safety instructions included therein must be observed.
DANGER:
It is strictly prohibited to disable the safety equipment or modify its mode of operation.
4.9 Installation of replacement and wear parts
Please be advised that replacement and accessory parts that have not been supplied by the
manufacturer have also not been inspected or approved by it. Installing or using such products and
similar can constructively modify the specified properties of the device in a negative way. The
manufacturer shall not be liable for any damages that arise from the use of non-original parts and
non-original accessory parts.
4.10 Storage of the product
To store the myDatalogNANOamr , activate the transport lock, by setting the "Operation mode" in
the input screen of the myDataweb server to configure the device (see "Device-specific settings" on
page 55) to "OFF". Then activate ALOHA transmission mode (see "ALOHA transmission mode" on
page 23) via the solenoid contact so that the amended configuration is transferred to the
myDatalogNANOamr . During this process, all of the data that has not yet been transferred to the
myDataweb server is transferred. The cables and antenna can be removed as soon as the GPRS
connection has been deactivated - indicated by the status LED going out (see "Status LED" on page
46). Store the myDatalogNANOamr in its original packaging. The battery pack remains in the device.
The myDatalogNANOamr is placed in energy-saving mode by activating the transport lock. However,
it may still occur that the battery pack is fully discharged if the device is stored for very long periods.
Although the configuration and the most recently determined data are definitely maintained. The
transport lock is deactivated again by re-initiating ALOHA transmission mode (see "ALOHA
transmission mode" on page 23) and the myDatalogNANOamr resumes operation according to the
configuration.
4.11 Obligation of the operator
WARNING:
In the EEA (European Economic Area), the national implementation of the framework
directive (89/391/EEC) as well as the associated specific directives and from these in
particular, the directive (89/655/EEC) about the minimum safety and health requirements for
use of work equipment by workers at work, each in their respective version are to be
complied with.
The operator must obtain the local operating licence and the associated documents.
18 Rev. 01