Microtronics myDatalogEx, Руководство пользователя, Страница: 52 / 84

The display of the myDatalogEx is activated as soon as the reed switch is pressed. The time for which the
reed switch was pressed is visualised by a circle in which the segments change from white to green. Setup
mode is activated once all of the segments have switched from white to green, i.e. the reed switch has been
pressed for at least three seconds (see "Setup mode" on page 27).
... ...
Visualisation of the time for which the reed switch was pressed
10.1.1.2 Display
Important note:
l
Do not touch the display with a sharp object, such as the tip of a pen.
l
Do not stand or place any objects on the display as this could scratch it.
The display of the myDatalogEx is only designed to show the current measurement values. The device
cannot be operated via the display. The display is activated by briefly holding the magnet (approx. 1 sec.) to
the reed switch (see "Reed switch" on page 51). The display then remains active for 20sec. and shows the
current operating state.
Status indication during normal operation
1 GSM level during last connection 4 Internal device temperature in °C
2 Current state of charge in % (SOC) 5 Remaining days until the batteries for the device
need to be replaced
3 Current value (incl. unit)
52 Rev. 05