TS631
Reworded 13 November 2013
Page 1 of 4
MICROSOUND
AC/DC Modified TS631 Manual
Step-by-Step Directions for programming TS631 Time Switch
Power On - Time Switch goes into time mode displaying
Microsound TS631, the current day and time
.
WHEN PROGRAMMING IS FINISHED, THE TIME SWITCH MUST BE IN THIS MODE
.
To ring the bell manually, press
B
while in this mode
D
Changes to the next mode
#
Changes back to the last mode
Please Note
that it is normal for the unit to loose +/- 60seconds over a month or two. To adjust the current time,
please go to step
No. J
below. <<TIP: Use Telkom
’
s time line Tel: 1026 to get exact time>>
A.
ENTER NEW ALARM (To set the alarm time i.e. when the bell/siren must be triggered)
1. Press
D
once to go into
“Enter new alarm”
mode.
2. Press
*
once to start programming the alarm times
3. Press:
1
for Monday /
2
for Tuesday /
3
for Wednesday /
4
for Thursday /
5
for Friday /
6
for Saturday /
7
for Sunday,
the cursor will then jump over to the zeros.
4. Enter time in 24 hour format hours 00: minutes :00: seconds :00
Note: Seconds must always be 00
E.g.
0 7 :4 5 :0 0
or
1 2 :0 0 :0 0
.
5. Press
A
to accept your new alarm. To clear an alarm time, press
C
.
6. Display will again show: Mon 00:00:00
7. Continue entering your alarms. When finished press
D
or
# .
B.
VIEW ALARMS (To check the alarms that have been programmed)
1. Press
*
to view the times that have been programmed.
2. Press
B
to move forward to the next time. This can be done until the display shows “
No more
Alarms
”. To move b
ack through alarms press
A
.
3. To delete only a selected alarm, press
C
while the alarm is shown on the display. The display will
show the next alarm.
4. Press
#
to go back to the time mode or
D
to go to the next mode
Содержание TS631
Страница 3: ......
