GBE Switch Module 1x 10/100/1000Base-T 7x 10/100Base-TX, 2x SFP
Page 5/8
MICROSENS
GmbH & Co. KG - Kueferstr. 16 - D-59067 Hamm / Germany - Tel. +49 (0)2381/9452-0 - Fax -100 - www.microsens.com
Management
The integrated http server offers to show status information by using a standard
internet browser. A special configuration is not necessary. Additional to the web based
management the switch offers a MIB to be used in all standardized Network
Management Systems (NMS) supporting SNMPv1 protocol.
With the PC based management tool Device Manager it is possible to configure all
ports of the switch manually. Please refer to the online manual for the Device manager
on the disk.
With this tool it is also possible to do the initial TCP/IP setting (IP address, Gateway etc.).
This configuration can be changed afterwards using the TCP/IP protocol.
Attention:
The description for the initial settings can be found in the online manual!
The management information are available inside of the network (inband
management). A special connection is not necessary. Due to this all four twisted pair
ports are available to connect other devices.
With the deactivation of the autonegotiation function of the twisted pair ports the
configuration of the speed to 10 or 100 Mbit/s and full or half duplex mode is done
manually.
Ring Function
The two main SFP ports of the device can be used to build up a ring structure.
Ring structures are commonly used in industrial and telecommunication environments
as they give redundant protection against failures at minimum cabling expense.
