VSC8574 Evaluation Board
VPPD-03067 VSC8574 User Guide Revision 2.0
6
11.
a.
b.
c.
12.
13.
Use the following commands to complete configuration of the Rabbit board:
Set netmask xxx.xxx.xxx.xxx
Set gateway xxx.xxx.xxx.xxx
Save env
Please record and inform Vitesse of the new IP address of the board when you return so that Vitesse
can connect to and reconfigure the board.
Re-label the Rabbit board with the new IP.
4.4
Using the Control Software
Connect the VSC8574EV Rabbit microcontroller RJ-45 directly to the PC or through a network switch if
properly configured. Apply +5VDC to the EVB.
Launch the GUI by double-clicking the GUI shortcut located in C:\TeslaGUI_4_65 or on the desktop if it
has been moved there. The GUI Connection window shown in Figure 3 should appear.
Figure 3 • GUI Connection Window
To make a connection to the EVB, click “Rabbit” and enter the IP address of the EVB, then click on
