MicroPower Access 30, Инструкция по эксплуатации

Страница: 3 / 198

ENGLISH
Access™ Battery charger
- Instruction for use
General
Access™ battery charger is available in different
models. The battery charger is, via parameter
settings, configurable through the control panel.
The charger is delivered with a set of built-in
charging curves, optimized for different type of
batteries.
The battery charger is intended to be continuously
connected to the mains supply.
The charging process starts automatically when
the battery is connected. The charger's control
panel show the charging process.
The charger can be connected to:
• Access™ Battery Monitoring Unit, BMU.
The charging process is adjusted after the
battery temperature, etc. Information is stored
and can be read by the PC application
Access™ Service tool.
• An external Battery Management System, BMS.
The battery charger can be configured so that
voltage and current is controlled via CAN-bus.
BMS then controls the charging process.
• Access™ Service tool.
The charging process can be monitored on
a PC. Access™ Service tool is connected to an
USB port.
Safety
Warning information
Hazardous situations and precautions are
presented in the text as follows.
Warning
Indicates a potentially dangerous situation. Death
or serious injury may occur if appropriate
precautions are not taken.
Caution
Indicates a situation where damage or injury could
occur. If it is not avoided, minor injury and/or
damage to property may result.
Note:
General information not connected to safety for
person or the product.
General
Always keep this manual nearby the
product.
The manual contains important safety
and operating instructions.
Read and understand this instruction, the battery
instruction provided by your battery manufacture,
and your employer’s safety practice, before using,
installing, or servicing the product.
Only qualified personnel should install, use, or
service this product.
ELECTRICAL SHOCK
The battery charger contains voltage at
a level that can cause personal injury.
Warning
High voltage!
Disconnect the battery and power supply before
maintenance, servicing, or dismantling.
Do not touch uninsulated battery terminals,
connectors, or other live electrical parts. Do not
penetrate the ventilation slots with any object.
Check that the power supply at the site of the
installation complies with the rated voltage
specified on the battery charger’s data label.
Before connection, check the marking on the
battery and the battery charger.
The battery charger may only be connected to a
power outlet with protective earth.
Do not operate the charger if there is any evidence
of damage.
3