Setup
The Setup program is used to configure the computer’s BIOS (Basic Input/
Output System). The computer’s BIOS is responsible for customizing the
operating system to your specific computer. In order for the computer to run
properly, run the Setup procedure after first installing the system board and
whenever you make a major change to the system.
After the system is turned on and goes through a memory test, the Power-Up
Screen (Figure 4-1) will appear on your monitor:
Figure 4-1 Power-Up Screen
After the screen appears, press the <F2> key to begin the Setup procedure.
The CMOS Main Screen (Figure 4-2) should appear and the prompt should
be on the time line. If the Power-Up Screen does not appear but a DOS
prompt does (ie. A:\ or C:\), press the <Ctrl>, <Alt>, and <s> keys simulta-
neously to begin the Setup procedure.
Micronics M4Pe System Board Manual
4-2
