Communicate via
P/N 2300-0751
6
5
7
WEEE Directive & Product Disposal
At the end its serviceable life ,this product should not be treated
as household or general waste. It should be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment, or returned to the supplier for disposal.
CE Mark Warning
This equipment complies with the requirements relating to
electromagnetic compatibility of the essential protection
requirement of Council Directive 2004/108/EC on the approximation
of the laws of the Member States. Company has an on-going policy
of upgrading its products and it may be possible that information in
this document is not up-to-date. Please check with your local
distributors for the latest information. No part of this document can
be copied or reproduced in any form without written consent from
the company.
w w w . m i c r o n e t . c o m . t w
Quick Installation Guide
Model No.: SP6528
24-port G 4-port SFP
Managed Switch
Configuration
Web-based User Interface
Before using web management, install the SP6528 on the network
and make sure that any one of the PCs on the network can connect
with the SP6528 through the web browser. The default IP, subnet
mask, username and password are as follows:
IP Address:
192.168.2.10
Subnet Mask:
255.255.255.0
User Name:
admin
Password:
admin
InBand Management
Secure Shell (SSH) management or Telnet Interface
When the connection between SP6528 and PC is ready, turn on the
PC and run a terminal emulation program or Hyper Terminal and
configure its communication parameters to match the following
default characteristics of the telnet port:
Host:
192.168.2.10
Port :
23
Connection Method:
TCP/IP (Winsock)
After finishing the parameter settings, click
"OK"
. When the blank
screen shows up, press
Enter
key to bring out the login prompt.
Key in the
"admin"
(default value) for the both User name and
Password (use
Enter
key to switch), then press Enter key and the
command line interface of InBand management appears.
----------For more details, please refer to user manual.--------
