5
P/N: 2300-0444
Quick Installation Guide
ADSL2+ Modem Router
Model No.: SP3361/SP3364F
Web: www.micronet.com.tw
6
7
FCC Certifications
Hardware Installation
1. Plug the provided RJ-11 cable into
ADSL
port on the router and
insert the other end into Modem jack on splitter or phone jack on
the wall.
2. Take the RJ-45 Cable, plug one end into LAN port on the router
and other end into the PC's Ethernet port.
3. Plug power adapter to
POWER
jack on the router and the other
end to a power outlet. Press On/Off to power on this router.
1.
1.
1.
1.
Access Management Web UI
1. Check the computer's network has been configured to get IP
automatically or has IP in the same network of 192.168.1.0.
2. Verify IP status by DOS command (
ipconfig
for Windows
2000/XP or
winipcfg
for Windows 95/98).
3. Open Internet browser, enter the default IP address in the URL
line, Press Enter to browse the router.
The authentication page pops up. Key in the password then click
OK
to access the web UI.
Default IP Address :
192.168.1.1
User name :
admin
Password :
admin
1.
1.
1.
1.
4.
Configuring Connection Mode
Here describes the settings of PPPoE/PPPoA. Please refer the
manual on the CD if other connection modes adapted.
1. Prepare the ADSL account information provided from your ISP.
It should include the items list below:
a. Encapsulation: PPPoE, PPPoA
b. Multiplex: VC or LLC
c. Virtual Circuit ID: VPI/VCI
d. User name and password
2. Once login the web UI, open
Quick Start
and click
RUN
WIZARD. Quick Setup
page will pop up on the screen.
3. Click
Next
then enter the new password and confirm the entry.
4. Click
Next
. Select time zone of your location then click
Next
.
5. Select
PPPoE/PPPoA
then click
Next
.
6. Type in your user name, password, VPI/VCI values and select
the correct Encapsulation mode. Click
Next
twice to save the
setting in this router. Wait the window turns to next page, click
Close
to close the page.
7. Under
Maintenance
, find
Time Zone
page, click
Save
to enable
SNTP service thus this router can get the current time from
Internet time server.
8. Go to
Status
. Scroll down the page, the ADSL line has been set
up while
WAN
table showing
CONNECTED
and getting IP from
ISP.
9. Now, client can surf Internet via this router.
1.
1.
1.
1.
1.
1.
1.
1.
1.
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
9.
9.
9.
CE Mark Warning
This is a Class B product. In a domestic environment, this product
may cause radio interference, in which case the user may be
required to take adequate measures.
PS.: For more inforamtion please refer the manual on the CD.
