Page
12
of
14
3/31/2022
Examples
Learn in a User ProxCard
Press and hold the
P
on the lock keypad for 5 seconds. The green LED will illuminate.
Enter
31
followed by the
P
. The green and yellow LED will illuminate.
Enter the
master code
followed by the
P
. The Green LED will flash.
Present the ProxCard to the lock (shown in Figure 1). Three beeps indicate the
ProxCards is read.
Repeat for additional ProxCards.
When finished press P for 5 seconds.
Unlocking
With a ProxCards:
Present the valid ProxCard to the lock. The MicroIQ icon should
illuminate. If not, press the
P
to wake the lock and present the ProxCards card again.
The green LED will illuminate and the knob can be turned to the unlocked position. The
lock will remain unlocked for 5 seconds.
Note: After an unsuccessful ProxCards read or a re-locking event, the lock will delay for
6 seconds before attempting to read any ProxCards.
With the keypad
: Enter a valid keypad code. The green LED will illuminate and the knob
can be turned to the unlocked position. The lock will remain unlocked for 5 seconds.
Using the Master ProxCard
The master ProxCard can be used to quickly add and remove ProxCards.
Learn in a User ProxCard
Press and hold the
P
on the lock keypad for 5 seconds. The green LED will illuminate.
Enter
31 f
ollowed by
P
on the lock keypad. The red LED will flash.
Present the master ProxCard to the lock. The green LED will flash.
