PolarFire MPF300T FPGA Video Kit
50200872 UG0872 User Guide Revision 1.0
6
3
Hardware Settings
This section provides information about jumper settings, switches, LEDs, and DIP switches on the
PolarFire video board.
3.1
Jumper Settings
Connect the jumpers according to the settings specified in the following table.
Table 3 • Jumper Settings
Jumper
Description
Pin(s)
Default
J15
SPI Slave and Master mode selection. By Default
SPI master
1-2
Closed
J19
XCVR_VREF is connected to GND
1-2
Closed
J28
Close pin 1-2 to program through the FTDI Open
pin 1-2 to program the external Flash pro5
1-2
Closed
J24
Jumper to select the PolarFire VDDAUX4 for
Bank4 voltage
Close pin2-4 for 3V3
Close pin2-4 for 2V5
Closed
Open
J25
Jumper to select the PolarFire VCCIO voltage
(VCCIO_HPC_VADJ)
Close pin 1 and 2 for 3.3 V
Close pin 3 and 4 for 2.5 V
Close pin 5 and 6 for 1.8 V
Close pin 7 and 8 for 1.5 V
Close pin 9 and 10 for 1.2 V
Open
Open
Closed
Open
Open
J36
Jumper to select the SW3 input or the
ENABLE_FT4 232 signal from the FT4232H chip
Close pin 1 and 2 for manual power switching
using SW3
Close pin 2 and 3 for remote power switching
using the GPIO capability of the FT4232 chip
Close
Open
3.2
LEDs
The following table lists the power supply LEDs.
Table 4 • LEDs
LED
Description
DS14-Green
12 V voltage rail
DS20-Green
5 V voltage rail
DS21-Green
3.3V voltage rail
DS5-Green
1.0V voltage rail
DS4-Green
1.8V voltage rail
DS3-Green
VDD25 Voltage rail
DS2-Green
VDDAUX2_5 Voltage rail
