Microchip Technology HV2918, Руководство пользователя

Страница: 13 / 60

HV2918 ANALOG SWITCH
EVALUATION BOARD
USER’S GUIDE

2020 Microchip Technology Inc. DS50003006A-page 13
Chapter 2. Installation and Operation
2.1 GETTING STARTED
The HV2918 Analog Switch Evaluation Board is fully assembled and tested. The board
requires five power supply voltage rails of +3.3V, +5V, +10V and ±100V.
2.1.1 Additional Tools Required for Operation
1. An oscilloscope with a minimum of 500 MHz bandwidth and two high-impedance
probes. Make sure the grounds of the power supply sources are correctly
connected to the same ground as the testing oscilloscope ground.
2. A Microchip HV MUX Controller Board (ADM00825).
3. A Microsoft
®
Windows
®
7 PC with the HV MUX Controller Board GUI software
installed and running.
4. J1 and J2 connected to the HV MUX Controller Board.
5. HV MUX Controller Board connected through the USB port to the PC.
2.2 HV MUX GUI INSTALLATION
The HV MUX GUI software installer can be downloaded from the Microchip website at
www.mircochip.com . Search for the evaluation board on the website by the part
number: EV19W62A .
1. Open the
HVMUXGUI-v1.0.0-windows-installer.exe
.
2. Initiate the HV MUX GUI software installer by launching the Application Install
dialog box.