Microchip Technology HV2722, Руководство пользователя

Страница: 13 / 58

HV2722 ANALOG SWITCH
EVALUATION BOARD
USER’S GUIDE

2019 Microchip Technology Inc. DS50002810A-page 13
Chapter 2. Installation and Operation
2.1 GETTING STARTED
The HV2722 Analog Switch Evaluation Board is fully assembled and tested. The board
requires six power supply voltage rails of +5V, +10V, ±135V and ±150V. The +5V is
supplied from the HV MUX Controller Board and the others need to be supplied from
external power supplies.
2.1.1 Additional Tools Required for Operation
1. An oscilloscope with minimum 500 MHz bandwidth and two high-impedance
probes. Make sure the grounds of the power supply sources are correctly
connected to the same ground as the testing oscilloscope ground.
2. A Microchip HV MUX Controller Board (ADM00825).
3. A Microsoft
® Windows ® 7 PC with the HV MUX Controller Board GUI software
installed and running:
- Connect J1 and J2 to the HV MUX Controller Board
- Connect the HV MUX Controller Board through the USB port to the
Windows 7 PC
2.2 HV MUX GUI INSTALLATION
The HV MUX GUI software installer can be downloaded from the Microchip website at
www.microchip.com . Search for the evaluation board on the website by the part
number: ADM00946.
1. Open the
HVMUXGUI-v1.0.0-windows-installer.exe
.
2. Initiate the HV MUX GUI software installer by launching the Application Install
dialog box.
3. Click Next to start the installation.