EVB-SEC1110/EVB-SEC1210/EVB-SEC1212-DEV
Evaluation Board User’s Guide
DS00001574A-page 22
2013 Microchip Technology Inc.
2.6.1
Placing a Chip in the Socket
This section is applicable only if the ASIC is not directly soldered on the PCB and the
EVB is equipped with a socket. The following guidelines must be followed when replac-
ing the ASIC in the socket.
Place the ASIC in the socket in such a way that the Pin1 marking (dot) on the ASIC and
the socket Pin1 marking on the PCB (triangle) align, as shown in Figure 2-5.
FIGURE 2-4:
EVB-SEC1210 COMPONENT SIDE TOP LAYER
Note:
The socket is manufactured by R&D Interconnect (P/N: 106458-0133).
