1
IMPORTANT INFORMATION AND SAFTEY INSTRUCTIONS
INFORMATION
Installers should be qualified electricians or technicians
The installation information in the manual is for information purposes only.
The monitoring and operation information in this manual is intended for anyone who needs to
operate the MPPT.
Read the instructions carefully before installing and operating the MPPT.
MPPT connection and installation instructions must be followed.
The unit should only be opened by skilled personal.
Retain the load within in the rating of MPPT to prevent faults.
Keep the MPPT clean and dry.
The MPPT will not operate without batteries.
The MPPT should be installed indoors, in a ventilated and dry area.
Mount the MPPT vertically.
Do not install the MPPT on a rugged or inclined surface.
Do not install the MPPT near water or in damp environments.
Do not install the MPPT where it would be exposed to direct sunlight.
Do not remove the MPPT casing unless the unit needs to be programmed.
Keep the MPPT away from heat emitting sources.
Do not block the MPPT ventilation openings.
Do not leave objects on top of the MPPT
Do not expose the MPPT to corrosive gasses.
Install the MPPT away from any explosive gasses.
Ambient temperature: 0°C
– 40°C
Sketches are intended for illustrative purposes only and are not intended to provide an
electrical design.
Damage caused by reverse polarity is not covered by warranty
.
Do not exceed the MPPT 50 Volt
maximum input voltage (Voc) rating.
Refer to your solar module documentation for the worst-case (coldest) module temperature
voltage, it should provide the V
oc
vs. temperature data.
WARNING
High AC voltage present and is capable of causing severe injury.
.
