MicroBT WhatsMiner M20S, Руководство по эксплуатации

Страница: 15 / 32

15 / 32
whether the switch is normal, the network cable connection is reliable, and
the quality of the network cable is faulty.
（
3
）
The computer and miner running the WhatsMinerTools software must be on
the same network segment. Otherwise, the software may not receive the
broadcast message from the machine, so that the ip address and mac
address information reported by the machine ipfound button cannot be
queried.
（
4
）
If the computer and the mine machine are on the same network segment, and
the DHCP service is enabled in the network, after the mining machine
ipfound button, WhatsMinerTools software does not query the IP of the
machine, long press the reset button on the machine panel for more than 5s
to recover Factory default configuration, then power off the mine machine
and then power on and restart, power on 30s and then press the ipfound
button to detect the mine IP address.
（
5
）
If the computer is running WhatsMinerTools software, click "Start", without
manually pressing the ipfound button, the software automatically finds the IP
address and mac address of the machine. At this time, the ipfound button of
the miner may be stuck by the panel, find the software. Display the miner
corresponding to the mac address (the mac address bar code is attached to
the miner panel), power off the corresponding miner, and then re-install the
control board to ensure that the control panel buttons and indicators are
exposed to the mounting holes, and are not stuck.
5.2.Configuration Pool&Worker Data and NTP Server
Address
5.2.1.Configuration Pool&Worker
（
1
）
After logging in,go to the configuration-Cgminer configuration page.
（
2
）
In the configuration-Cgminer configuration page,modify the mine pool address,mine
worker name,after modifying, click “Save & Apply” in the lower right corner to save the modified
configuration.