Page 7
scanCONTROL 3010 / 3012
8.
Quick Start, Initial Operation, Software
Mount the sensor according to the installation instructions.
Install the software.
You will find the software online on the product
website of the sensor or in the download area:
https://www.micro-epsilon.
com/2D_3D/laser-scanner/Soft-
ware/downloads/
Follow the dialog through the installation
process:
A. Reading the installation help
B. Installing the software
C. Additional information in the online
documentation
Connect the sensor to the PC using the optionally available SCR3000A-x Ethernet
cable.
Connect the shield of the power supply cable to the PE grounding conductor of
the main power supply. Close unused connection plugs with the included
protective caps. Turn on the power supply (24 VDC).
Please wait until the scanCONTROL measuring system is recognized by the PC.
This may take a few seconds.
Now you can operate the scanCONTROL measuring system with the
scanCONTROL software packages.
i
Operating a scanCONTROL sensor via Ethernet may require the IP settings of the
PC/sensor or the firewall settings to be adjusted, see Chap. 5.2.5 of the operating
instructions.
The connectors for Ethernet and the multifunction port include a screw connector.
Loosen the screws connection before you remove the connector from the socket.
i
Only connect the sensor to the peripheral equipment, if it is disconnected from
the power supply, i.e. only when the operating voltage is switched off. The sensor
needs a warm-up time of typically 20 minutes for high precision measurements.
