MICRO-EPSILON 4350127.256, Руководство по эксплуатации

Страница: 37 / 173

Page 37
Instruction Manual Software
thicknessCONTROL MTS 8202.LLT / 4350127.256
5.8 User settings for display Carry out Routine Measurements
5.8.1 Stop Measurement
With the entry
Stop
measurement is stopped and the measurement carriage traverses to
parking position.
5.8.2 Move to Position
Via the menu
Fix position
manual specified positions for measurement can be
traversed.
By means of the dropdown array, you can choose whether the measurement position is
to be determined in [mm] or [inch] ensuring from the parking position of the traversing
unit or if the specified measuring point is to be traversed.
Fig. 39 Menu Move to position
Traversing to a measuring point is only reasonable after traversing measurement. When
the fix position has been confirmed with the green button
Go
the measurement carriage
traverses to the stated position. When the target position has been reached measure-
ment starts.
Fig. 40 View Length profile - fix position
In the upper trend view measuring values of the last 60 seconds are displayed. Current
motor position and current thickness are displayed below. The virtual green LED
Posi-
tion reached
signalizes reaching the measurement position.
Gathered measurement data is saved in an ASCII file in the archive folder. The file con-
tains length, relative date [min] and the measuring value.
The file name is composed of:
FixPo Date/Time + Measurement position .txt
E.g. the file
FixPosition_20150916_153537_150mm.txt
was gathered in fix track
mode on 09/16/2015 at 3:35:37 PM at position 150 mm.