MICRO-EPSILON 4350127.256, Руководство по эксплуатации

Страница: 13 / 173

Page 13
Overview of Mechanical Components
thicknessCONTROL MTS 8202.LLT / 4350127.256
3. Overview of Mechanical Components
This third volume of the manual explains the mechanical commissioning. The mechan-
ical design and its way of working start in the second chapter with the components of
the base frame. Then, calibration is explained. The third volume is rounded off with the
electrical connections of the measuring machine.
3.1 General Points before Commissioning
The MTS 8202.LLT measuring machine achieves a resolution in the micrometer range.
For this reason, the mechanical components and sensors are matched to each other in
every detail. Insofar as is constructively possible, mechanical assemblies and individual
parts which are not subject to adjustment have been used. Such parts/assemblies which
have to be adjusted for functional reasons have been adjusted by Micro-Epsilon.
The commissioning of the MTS 8202.LLT does not require any adjustment work by the
customer. The customer is responsible for providing a protective device to avoid a colli-
sion between the belt/strip material (target) and the measuring machine.
3.2 Basic Components
3.2.1 Base Frame
1 2 6 3 4 5
1 Triangulation scanner
2 Calibration object
3 Linear guidance
4 Base Frame
5 Cable carrier
6 Drive
Fig. 8 Measuring machine (C-frame) with linear guide
The base frame with the upper and lower beams is the basis of the system. It holds the
triangulation scanners and the remaining components. The base frame consists of a
solid aluminum profile frame.
The linear guide and the drive for the horizontal displacement of the base frame are on
the bottom of the measuring machine
- for positioning the measuring machine on the target,
- for calibrating the measuring machine with the calibration object (= reference).
CAUTION
Crushing or shear-
ing hazard caused by
uncontrolled movement
or moving parts. The
operator is responsible
for safeguarding.