MICRO-EPSILON 4350006.71, Руководство по эксплуатации

Страница: 9 / 254

Page 9
Overview, Technical Data, Safety Instructions
thicknessCONTROL MTS 8201.LLT / 4350006.71
When replacing large components, these must be carefully attached to and secured
on lifting equipment using the attachment points provided on the system. Loosened
screw joint be checked for tightness. After completion of the maintenance work, the
safety devices must be checked for functionality.
- Structural modifications to the measuring system: No modifications, attachments to
or conversions of the measuring system may be made without the permission of the
manufacturer. All conversion measures require the written approval of Micro-Epsilon
Messtechnik GmbH & Co. KG. Parts of the system that are not in trouble-free condition
must be replaced immediately. In addition, only original spare and wear parts must be
used. Parts obtained from third parties are not guaranteed to have the correct design
with regard to load and safety.
- Cleaning and disposal of the system: The substances and materials used must be
handled and disposed of properly, in particular when:
ƒ working on lubrication systems and equipment
ƒ
cleaning with solvents.
- System noise: The continuous sound pressure level emitted by the system is less than
70 db(A). Depending on the local conditions, a higher sound pressure level may be
produced, causing noise-induced hearing loss. In this case, the operating personnel
must be protected by appropriate safety equipment or safety precautions.
- Fire-fighting: It is vital to switch off the system at the main switch during fire fighting,
otherwise fires caused by electricity cannot be effectively extinguished. The internal
alarm and fire protection regulations of the operator (customer) must be complied
with.
- Reversal in the case of emergency: A reversing device is not provided in the event of
an emergency.
1.4 Training of Personnel
- Only trained and instructed personnel are permitted to work on the system.
- The responsibilities of the personnel for operating, retooling and maintenance must
be clearly specified. Personnel undergoing training are only permitted to work on the
system under the supervision of an experienced person.
ƒ Only instructed personnel are permitted to operate the controller.
ƒ
Instruction should be acknowledged in writing.
ƒ
The persons operating the system (instructed persons) must be computer literate
(i.e. possess skills with common PC programs).
User group Task Qualification
Technical staff Initial operation, maintenance,
repair
Technical education
Operating
personnel Operating Instruction, experienced/trained
1.5 Foreseeable Misuse
If the target/strip material flow has started, the calibration part holder may not be retract-
ed. Collision of the target/strip material with the calibration part holder.
During the reference measurement, the target/strip material flow may not be started.
Collision of the target/strip material with the calibration part holder.