MICRO-EPSILON 4350006.71, Руководство по эксплуатации

Страница: 107 / 254

Page 13
Laser Safety
scanCONTROL 29xx
2.2 Laser Class 3B
scanCONTROL 29x0 sensors with a maximum laser power up to 20 mW, see Chap. 3.2 , are classified in
Laser Class 3B (IIIB).
i
Sensors of laser class 3B (IIIB) need an external key switch to switch off the laser, see Chap. 5.2.6 . Ac-
cordingly, the following applies: The available laser radiation is hazardous for the eyes and usually for
the skin also. Looking directly into the laser beam is hazardous for the eyes. Also reflections on shining
or mirroring surfaces can be hazardous to the eye.
If the sensor is on the laser output can be reduced to 8 mW with the software. Reducing the laser output to
1 mW is not possible. Reducing the laser output from 20 mW to 8 mW with a software affects not the laser
class!
The following information label should be fitted to the sensor housing (front and rear side):
IEC 60825-1: 2015-07
P

50mW, P

50mW;
0 P

= 658nm; F = 0...4kHz, t = 1 µ s...
∞
Warning- Laser radiation
Avoid exposure to beam
Class 3B Laser Product
The laser labels for Germany are
already printed on. The labels
for the EU area and the USA are
enclosed and must be fitted by
the user for the region applicable
in each case before the equip-
ment is put into operation.
Fig. 6 IEC label Fig. 7 Only for USA
i
If both information labels are hidden in the installed state, the user must ensure that additional labels
are fitted at the point of installation.
When using lasers of
3B class appropriate
protective glasses are
necessarily!
Injury of the eyes and
the skin by laser radia-
tion!