Michco sc8000, Руководство по обслуживанию

Страница: 176 / 225

Solution System 175 Service Manual – SC8000
To Clean the Extended Scrub System Strainer
1. Open the recovery tank cover.
2. Rinse any accumulated material off of the extended scrub system strainer using normal water hose
pressure.
3. Close the recovery tank cover.
To Clean the Solution Delivery Trough
Clean the holes in the solution delivery trough to ensure even solution distribution.
To Clean the DustGuard™ Spray Nozzles
Note: Place a suitable container underneath the nozzles to catch any water that may leak from the
hoses.
1. Hold the
Plastic Nozzle Adapter
with a
7/8” Wrench
to
keep it from rotating in the
Spray Nozzle Bracket
when
you remove the
Nozzle Cap
. This will maintain the
correct spray pattern orientation of the
Spray Nozzle
.
2. Rotate the
Nozzle Cap
one-quarter turn
counterclockwise (as viewed from the front of the
machine) to remove the
Nozzle Cap
,
Spray Nozzle
and
Check Valve Strainer
from the
Plastic Nozzle Adapter
.
3. Rinse the
Nozzle Cap
,
Spray Nozzle
and
Check Valve Strainer
in clean water
to remove any accumulated dirt or
sediment. If necessary, rinse or soak
the components in vinegar or other
commercial cleaner to remove any
mineral deposits.
4. Reassemble the DustGuard™ nozzles
by following the above steps in reverse
order.
To Adjust the DustGuard™ Spray
Nozzles
The
Spray Nozzles
should be approximately
10 to 20 degrees from vertical as shown
in order to spray the water evenly top to
bottom in front of the side brooms. The
spray pattern should wet the floor across
the whole width of the side broom. If the
spray pattern is not correct:
1. Carefully rotate the
Plastic Nozzle Adapter
with a
7/8” Wrench
to orient the
Spray Nozzle
.
Plastic
Nozzle
Adapter
7/8” Wrench
Nozzle
Cap
Nozzle
Cap
Plastic
Nozzle
Adapter
Brass
Nozzle
Adapter
Spray
Nozzle
Spray
Nozzle
Bracket
Check
Valve
Strainer