Mi-T-M CM-1400-0MEC, Руководство по эксплуатации

Страница: 21 / 32

Operator’s Manual 21
Operating the Washer
CLEANING WITH DETERGENTS
Refer to “Detergent Cleaning Precautions” before working
with detergents. Be certain to wear protective safety attire.
Prepare detergent solution according to label directions.
Never pump acids, alkaline, abrasive fluids or solvents
through the unit.
1. Immerse the detergent strainer into the detergent
solution to allow detergent to siphon.
2. With the trigger gun locked in the “OFF” position, secure
quick-connect the detergent spray nozzle (#6540°
BLACK) into the end of the wand.
Note: This injection system is designed to apply
detergents under low pressure only. It
will not allow detergent solutions to be
introduced into the system unless the
nozzle assembly is in the low pressure
detergent mode.
3. To apply solution; unlock the trigger gun and squeeze
the trigger. In a few moments a detergent/water mixture
will exit the low pressure nozzle. Start spraying the
lower portion of the surface being cleaned and move
up, using long overlapping strokes. Applying from the
bottom up helps avoid streaking. Allow to soak briefly.
Do not allow detergent solution to dry on the surface.
(Avoid working on hot surfaces or in direct sunlight to
minimize the chances of the detergent drying, which
may result in damaging painted surfaces.) Be certain
to rinse a small section at a time.
4. To rinse; lock the trigger gun in the “OFF” position,
securely quick-connect the desired high pressure
nozzle into the end of the wand. Unlock the trigger gun
and spray. It will take about 30 seconds to purge all
detergent from the line. For best rinsing results, start
at the top and work down.
5. Siphon a gallon of water through the low pressure
detergent injection system after each use. This
prevents the possibility of corrosion or detergent
residue causing mechanical problems during the next
use.