Mi-T-M CM-1400-0MEC, Руководство по эксплуатации

Страница: 16 / 32

Preparing the Washer
16 Operator’s Manual
IMPORTANT: If washer is to be connected to a well water
system, use 851-0207 water inlet filter (A).
This will increase sand filtering capability
and avoid damage to the pump.
CONNECT HOSES AND PRIME PUMP
1. Hose washer with screen (A) is already attached into
end of brass hose coupler.
NOTE: Conical screen in washer (A) should protrude out of
coupler and into flow from inlet hose.
2. Install inlet water hose (A) and hand tighten. Install high
pressure discharge hose (B) with quick connect.
A
A
↑
↑
↑
B
A
↑
3. Open water supply. Squeeze trigger on gun. Allow
water to run (with motor off) until water runs out of
pressure hose. Start motor and cycle trigger on gun
until “crackling” sound (air in lines) stops.