Mi-T-M Chore Master, Руководство по эксплуатации

Страница: 18 / 56

18 CM-Direct Driven Operator’s Manual 1996
TROUBLESHOOTING
SYMPTOM PROBABLE CAUSE REMEDY
Engine will not start. Various engine problems. Refer to the engine manual
accompanying your unit.
Unit components are frozen. Allow to thaw. If any part of the unit
becomes frozen; excessive pres
sure may build up in the unit which
could cause the unit to burst
resulting in possible serious injury
to the operator or bystanders.
No discharge at nozzle when Inadequate water supply. Ensure hose is 3/4” diameter and
trigger mechanism is squeezed. incoming water supply is turned on.
Kink in water inlet hose. Remove kink.
Low or fluctuating pressure. Kink in high pressure discharge hose. Replace hose.
Water inlet screen obstructed. Remove screen, clean or replace.
Pump sucking air. (Prime eliminated) Tighten all water intake connections
Eliminate leaks in intake line.
Not in high pressure mode. Insert a high pressure nozzle.
Obstructed or worn spray nozzle. Remove, clean or replace.
Damaged or obstructed valve assy. Remove, inspect, clean or replace.
on pump.
Pump packings worn. Replace packings.
Bypass valve not operating correctly. Repair or replace.
Water is leaking from the “Heat Water temperature is too high. Do not allow the unit to operate in
Dump Valve” the bypass mode (with trigger gun
closed) for more than 3 minutes.
Defective valve. Replace.
Oil appears milky or foamy. Water in oil. Change pump oil. Fill to proper
level.
Oil leaking from unit. DO NOT USE!!!!! Contact Choremaster Customer
Service.
Detergent will not siphon into Detergent strainer is not completely Check, submerge if necessary.
Low Pressure Detergent mode. submerged in detergent solution.
Detergent strainer obstructed. Inspect, clean or replace.
Detergent hose cut, obstructed or Inspect, clean or replace.
kinked.
Detergent adjusting knob on pump Open adjusting knob. Refer to
turned to closed position. (If applicable.) “Cleaning with Detergents” pg. 15
Not in low pressure mode. Insert 6540° (BLACK) nozzle.
Nozzle assembly is plugged. Clean or replace.
Too many high pressure hose Use one extension maximum.
extensions attached to the water outlet.
Ball & Spring in Venturi stuck. Remove, clean or replace.
Water flows back into detergent Ball & Spring in Venturi reversed, Remove, clean or replace.
container. missing or corroded.
Water flows from the nozzle when the Gun is malfunctioning. Repair or replace.
trigger gun is locked in the “OFF”
position.