MHS Boilers XenoROL XR40, Инструкция по установке, эксплуатации и обслуживанию, Страница: 13 / 84

XenoROL®
13
IT#: 40084360
DSC: DR,CTR 24XR40 3/4HP 60 B
JOB: C003325 11/10/96
RECEIVING & SITE PREPARATION
GENERAL
XenoROL® line-shaft driven live roller conveyors are
shipped in subassemblies. These subassemblies
are packaged to guard against damage in shipment.
Examination immediately following unloading will
show if any damage was caused during shipment.
If damage is evident, claims for recovery of
expenses to repair damage or replace components
must be made against the carrier immediately.
While unloading, a check must be made against the
Bill of Lading, or other packing lists provided, to
confirm full receipt of listed items.
CAUTION
TAKE CARE DURING THE REMOVAL OF
EQUIPMENT FROM THE CARRIER. Remove
small items and boxes first. Pull and lift only on
the skid, not on the frame, crossmember or any
part of the equipment. Be sure the skid is free of
other materials which may be on top of or
against the side of the skid to be removed.
PREPARATION OF SITE
After the conveyor is received, move it to the
installation site or designated dry storage area as
soon as possible. Clean up all packing material
immediately before parts get lost in it. Loose parts
should remain in the shipping boxes until needed.
Prior to starting assembly of the conveyor, carefully
check the installation path to be sure there are no
obstructions that will cause an interference. Check
for access along the path needed to bring in bed
sections and components closest to the point where
they are needed. It is often necessary to give the
area along the system path a general cleanup to
improve installation efficiency, access and accuracy.
Ceiling-hung conveyor header steel should be
installed well ahead of the conveyor frame
installation to minimize congestion.
PARTS INVENTORY & IDENTIFICATION
Each subassembly is shipped completely assembled
except typical loose parts which are listed on page
9.
Drive assemblies are shipped mounted to the
drive conveyor frame.
Segregate the conveyor subassemblies by types for
inventory and ease of locating during installation.
An identification label is attached to the inside of one
side channel close to one end of each conveyor bed
and on all drive packages. (See below.) This label
contains: job number, part number, order number,
tag number (if specified), assembler's initials and
date of manufacture. On supports, the tag is located
on the bottom side of the foot. On special devices it
is located on a convenient flat surface that is not
offensive to the appearance of the equipment but is
still accessible for viewing. These numbers can be
cross-referenced against the packing list. The
illustrations in this manual and the part number
stickers will assist you with your inventory.
Identification labels on
Bed and drive package
Loose parts are boxed and shipped separately. You
should have all conveyor sections and supports for a
particular conveyor prior to installation. It is cost-
effective to identify and procure any missing parts
before they are needed for assembly. Small items
like nuts and bolts are weigh-counted and packaged
by size and type.
IT#: X9503463
DSC: BED 24XR40-3D-X 10’
JOB: C003325 11/10/96
TAG: 101E
O-RINGS 90530005 90530009
90480006rev092010