Operating instructions iQ-Oval CDS V1-4.docx
page 25 of 66
7.11.2.
Squeegee Drive Motor
The squeegee/print arm motor is used to drive the squeegee carriage back and forth,
precisely controlled by the frequency inverter.
7.11.3.
Frequency inverter
The frequency inverter controls the squeegee drive motor. A full setup is made by MHM,
no further adjustment is needed.
7.11.4.
Squeegee/Print Arm
The squeegee carriage, squeegee stroke length adjustment, control keypad and control
knob for the squeegee pressure are all located on the squeegee arm.
7.11.5.
Screen Adjustment/Micro-Registration
The screen adjustment/micro-registration is used for the precise positioning of the
screens. Each screen may be positioned forwards/backwards by means of a single
handwheel adjuster located at the front of each individual print station. For left/right
adjustment there are two handwheel adjusters located at the front and rear of each
individual print station. Adjustment is free from play and self-locking, therefore no
additional clamping is required.
7.11.6.
Squeegee Stroke Length Adjustment
The squeegee stroke length adjustment may be used to adjust the precise travel of the
squeegee carriage. There are individual sensors on each print station to adjust the front
and rear positions. Minimizing the travel of the squeegee carriage helps to reduce
printing times and increase production.
7.11.7.
Squeegee/Print Arm Lock
Pressing the squeegee/print arm lock moves the entire squeegee/print arm upwards,
providing un-obstructed access to the screens and squeegees.
7.11.8.
Squeegee pressure control
Adjustment for squeegee pressure (with pressure indicator)
