8
UG-015
7.0
Pre Install SETUP & Installation.
To install an overshoe for type 01 or 02 laddersafe platforms…
With the Laddersafe already installed upon the box or panel, place the overshoe on the ground.
Two operatives, one each side of overshoe will be required.
Remove the ‘Pivot plate Lock Pin’ and tilt the pivot plates until the handles are pointing downwards.
The plates can be locked in the open position, or alternately the plates can be left unlocked
depending on operator preference.
With two operatives, one holding each of the ‘operative lift points’ – orientate the over shoe so the
‘ramp attachment points are facing out from the dig.
Lift the overshoe, over the Laddersafe platform. Both pivot plates should be rotated to close and
engage fully over the platform chassis. Each operative should transfer the load, so they move from
holding the ‘operative lift point’ – to be holding the ‘pivot plate -operative lift handle’. Once
correctly located, so that the location plate sits flush against the platform, each operative should fit
their ‘pivot plate lock pin’ to complete the fitting of the overshoe.
