LT-6666
Rev. 0 June 2019
1
QAS-2X8
Audio Splitter
Installation Instructions
1.1
Installation
The QAS-2X8 mounts on the rightmost side of the QX-mini(-BP) or AUDMAX-MASTER(-BP) board using
four spacers. The QAS-2X8 uses a ribbon cable for connections and power.
1. Replace one standoff for each screw on the right side of the QX-mini(-BP) or
AUDMAX-MASTER(-BP) board as shown in Figure 1.
2. Attach ribbon cable between P7 on the QX-mini(-BP) or AUDMAX-MASTER(-BP) board to P1 on
QAS-2X8 audio zone splitter board.
3. Place QAS-2X8 board so its screw holes align with the standoffs.
4. Secure QAS-2X8 using four screws.
Figure 1
Installing the audio zone splitter module
Note:
Ensure ALL AC and battery connections are disconnected before attempting to
install or remove any component. Otherwise, board damage may occur.
i
Main Board
Standoff
Audio zone
splitter
Screw
