MFZ Ovitor CS 320 FU, Руководство по эксплуатации, Страница: 50 / 76

50 – Control CS 320 FU / Rev.A 1.01
Function Description
Adjustment
options
Factory setting
BOOST
RUN UP Results in a voltage boost when ramping up/ramping down and generates an
additional torque each time accelerating/braking occurs. 0 – 250 V 50 V
BOOST START Voltage boost when starting. Useful for starting loads.
Only active after the first acceleration process following an ON command.
Setting a starting boost that is too high (BOOST START) results in the inverter limiting
the current strength, which means that the output frequency is limited to a value that
is lower than the nominal frequency.
NOTICE:
The voltage boosts increase the motor warming (in particular at zero speed).
The boost values are combined when continuous boost (BOOST KONST. parameter)
are used in conjunction with other boost parameters (BOOST BESL. acceleration boost
and BOOST START starting boost).
These parameters are assigned priorities, however, as follows:
BOOST CONT. > BOOST RUN UP > BOOST START
0 – 250 V 0 V
EXPERT
MENU Activation and deactivation of expert setting.
In the factory setting OFF, only a limited choice of parameters appears in INPUT mode.
If this parameter is set to ON, all parameters in the input menu can be called up and
set.
OFF: Limited number of parameter settings:
– Menu language
– INC.P.OP
– OPEN TIME
– FOREWARNING
– FAST CL.
– REVERS- POINT.
– INPUT 1
– SELF LOCK
– BRAKE P OP
– BRAKE P CL
– SPEED OPEN
– SPEED CLOSE
– SOFTRUN OP.
– SOFTRUN CL.
– SPEED UP OP.
– SPEED UP CL.
– SLO. DO. OP.
– SLO. DO. CL.
– MOTOR V
– MOTOR I
– MOTOR P
– MOTOR PHI
– MOTOR HZ
– MOTOR RPM
– EXPERT MENU
ON: Access to all parameters as listed in Chapter 11.2.
ON – OFF OFF
Functional overviews