MFJ-816 Instruction
Thank you for purchasing the MFJ-816 HF SWR
Wattmeter. The MFJ-816
measures
forward power, reflected power and SWR. The
wattmeter measures
power on two
scales, 30
watts and 300 watts. The MFJ-816
is usable from
1.8 MHz thru
30 MHz.
Installation
1.
Connect of a coax cable from the transmitter to the TRANSMITTER
Coax
connector of the MFJ-816.
2. Connect the antenna cable to the ANTENNA coax connector of the MFJ-816.
Operation 1. To Measure SWR:
Set the push button to the FWD/SET position. Transmit a continuous carrier and
set the SWR/POWER control for a full scale deflection on the meter. Set the
push button to the REF/SWR position and read the SWR.
Note: The SWR sensitivity must be reset when power level is changed.
This
will maintain and accurate SWR reading.
2. To Measure Power
300 Watt Scale
Set the SWR/POWER control to the 300 mark. Set the_ push button to the
FWD/SET position to read forward power and to REF/SWR to read reflected
power. This scale reads maximum of 300 watts.
3 0 Watt Scale
The 30 watt scale can be used to measure forward and reflected power up to 30
watts. To measure forward power, set the push button to the FWD/SET
position. To measure reflected power, set the push button to the REF/SWR
position.
The 30 Watts position is not calibrated at the factory because of variations
due to components tolerance. To calibrate the 30 watt scale, follow this
procedure: Set the push button to the FWD/SET position and the SWR/POWER
control to 300. Transmit a continuous carrier and not the power level on the
300 watt scale. Power from the transmitter should be set as close to 30
watts as possible without exceeding 30 watts. This will give the most
accurate calibration. Now rotate the SWR/POWER control so that the reading on
the 30 watt scale is the same as what was noted on the 300 watt scale. Mark
the dial for the calibrated 30 watt range.
