C
ompressed-air Stapling Plier
Z 23 P
Page:
23
Mod.:
01/2022
ET
Seite 23 von 34 31.01.22 P:\Technik\ZANGEN\Z 23 P\Bedienungsanleitung\Englisch\Manual Z 23 P Pneum en_01_2022.docx
13.11
Triggering the stapling device
To trigger the stapling device, proceed as follows:
Set the stapling device so that the carton is between the discharge (6) and the anvil (5)
Press the anvil (5) against the carton
Press the trigger (1) through the stroke
The discharge (6) contacts the carton
One staple is driven through the carton and bent at the anvil (5)
Release the trigger (1)
To drive additional staples, repeat these step
For optimal stapling of 30 mm thick carton, use ZH 16 38. Staples,
for 20 mm carton, use ZH 16 30, and for 16 mm carton, use ZH 16 25 staples.
13.12
Select carton thickness
You can set the stapling device for 16 mm, 20 mm, or 30 mm carton thickness. This ensures
optimal stapling with a clean closure shape.
WARNING
Accidentally triggering when selecting the carton thickness can cause severe
or fatal injury.
Do not point the stapling device at yourself, people or animals.
To select the carton thickness, proceed as follows:
Carton thicknesses are marked on the clip on the unit (10).
Open the clamp lever (8) by rotating the lever counterclockwise.
Remove the retaining ring (2) on the locking pin (7).
Pull out the locking pin (7).
Set the two clips (3) so that the holes (9) in the clip (3) align with the hole in the spacer (4)
below the desired carton thickness.
Insert the locking pin (7) through the aligned holes (9) and install the retaining ring (2) on the
locking pin (7).
Close the clamp lever (8) by rotating the lever clockwise.
The desired carton thickness is now set.
Carton thickness is set to 30 mm when the holes on the left are aligned. The center
holes are for 20 mm and the holes on the right are aligned for carton thickness of
16 mm.
