Pneumatic table stapler
TH 210
Page:
7
Change:
02/2019
ET
598
Page 7 of 12 21.02.19 P:\Technik\TH_THE_210\Bedienungsanleitung\Englisch\BA TH 210 02_2019_EN.docx
The following work processes/inspections should be performed by knowledgeable personnel on a
regular basis:
Regular oiling of the movable parts (no graphite oil!) - on a weekly basis
Check the filter controller for condensation. If necessary remove the condensation water.
Only ORIGINAL spare parts may be used. (see “spare parts list”)
Failure to comply will void any guarantee claim and exclude any liability!
All technical equipment, especially the safety equipment, must be inspected by qualified personnel after
repairs.
In order to maintain the operational readiness and function of the stapling device, it must be regularly
checked and cleaned by the operator or by qualified personnel.
11
Application area/designated use
The stapling device may only be used for the following purposes:
for stapling thin solid boards or plastic foils.
Do not staple into hard (e.g. metal plates, nails, etc.) and brittle materials.
This can damage the stapling device.
12
General/Function
The material to be stapled can be inserted into the stapling area.
Starting with the second insert stapler, this can be switched on or off via a manual slide valve on the
cylinder.
Insert the material to be stapled and push it to the valve stop. The stapling is triggered automatically.
Alternatively/optionally, the stapling can be triggered with an optional foot valve.
13
Reloading/inserting the staples
Zum Reloading Compressed air connection entfernen.
Unlock magazine
M
with lever
H
and pull out, insert
staples, insert magazine completely until it locks
automatically. Only use original staples, otherwise
stapling problems may occur.
Lever H
to unlock the
magazine
Magazine
M
Strip L
Trip
switch
Insert
stapler
