Pneumatic table stapler
TH 210
Page:
4
Change:
02/2019
ET
598
Page 4 of 12 21.02.19 P:\Technik\TH_THE_210\Bedienungsanleitung\Englisch\BA TH 210 02_2019_EN.docx
5
Ambient conditions/Emission
The stapling device should be operated at room temperature, protected against environmental
influences.
Use within an explosive atmosphere is permitted only with prior consent and written permission of the
manufacturer.
The noise emission is less than 70 dB(A).
Non-atmospheric gases are not released during the stapling process.
6
Operating personnel
Only trained and knowledgeable staff is permitted to operate the machine.
Note:
Competent, is someone who based on his training and experience has sufficient knowledge in
the field of stapling devices and is familiar with the relevant government industrial safety regulations,
accident prevention regulations and the generally accepted rules of technology (e.g. DIN standards,
VDE regulations) to the extent that he can assess the secure state of machines and in particular the
state of stapling devices.
7
Transport and initial commissioning
Before the stapling device is put into operation, please read all instructions in this manual. This stapling
device may only be put into operation by
trained
personnel.
The stapling device is delivered completely assembled and can be transported as a whole.
Transportation equipment can also be used for transporting the machine.
To make the stapling device ready for operation after delivery, the following tasks must be carried out:
-
Check the equipment for completeness
-
Load the stapling device with staples
-
Connect the compressed air
The air pressure is 4 - 6 bar overpressure.
It is necessary to install a filter regulator upstream which consists of a filter and a pressure regulator.
As a connecting hose, a hose with an internal diameter of 6 mm is requir ed.
Oxygen or combustible gases may not be used as a propulsion source for pressure
driven machines.
