Meyra 1.610, Руководство по техническому обслуживанию и ремонту

Страница: 67 / 104

67
Power module, replacing the lighting, resp.
lighting/adjustment module
1. Before replacing a module all plugged connections are
to be disconnected.
☞
In doing so it is recommended to place each plug that
is pulled directly into the new module.
☞
This prevents establishing incorrect plugged con-
nections.
2. Afterwards remove the screws of the defective module.
3. Remount the new module analogue in reverse order.
!
Attention:
It is to be observed that the cables are not damaged or
bent when being placed.
☞
Otherwise danger of fire through short circuits!
☞
Previously removed cable ties are to be replaced.
☞
Then carry out a function test.
☞
Therefore observe chapter Functional checks on
page 94.
Power module 1.610 / 1.611 / 1.614 / 1.615 / 1.616
The power module (1) is mounted according to the hole or-
der onto the frame plate [2].
Power module 1.612
The power module (3) is mounted in front of the battery
cover onto the frame plate [4].
Power module 1.617
The power module is mounted from the inside onto the
rear cover [5].
1
3
2
4
5