
PB-74/7500
- 7 -
MANUFACTURER’S WARRANTY
MEYER SUPER SPREADER
11 / 2014
I.
The “Owner's Registration Form” must be completed in full and promptly returned to Meyer Mfg. Corp.
for this warranty to become both valid and effective. All warranties on new Meyer Super Spreaders shall
apply only to the original retail customer from an authorized Meyer Mfg. Corp. dealership.
II.
This warranty shall not apply to any Meyer Super Spreader which has been subjected to misuse,
negligence, alteration, accident, incorrect operating procedures, has been used for an application not
designed for or pre-authorized by Meyer in writing, has had the serial numbers altered, or which shall
have been repaired with parts other than those obtained through Meyer Mfg. Corp. Meyer is not
responsible for the following: Depreciation or damage caused by normal wear, lack of reasonable and
proper maintenance, failure to follow the operator's manual recommendations or normal maintenance
parts and service. Meyer is not responsible for rental of replacement equipment during warranty
repairs, damage to a power unit (including but not limited to a truck or tractor), loss of earnings due to
equipment down time, or damage to equipment while in transit to or from the factory or dealer.
III.
Meyer Mfg. Corp. warrants new Meyer Super Spreaders to be free from defects in material and
workmanship under recommended use and maintenance service, as stated in the “Owner / Operator's
Manual & Parts Book” as follows:
A.
Meyer Mfg. Corp. will repair or replace F.O.B. Dorchester, WI, as Meyer Mfg. Corp. elects,
any part of a new Meyer Super Spreader which is defective in material or workmanship:
i.
Without charge for either parts or labor during the first (1) year from purchase date
to the original retail customer.
B.
In addition to the above basic warranty, Meyer Mfg. Corp. will repair or replace F.O.B.
Dorchester, WI as Meyer Mfg. Corp. elects:
i.
i.Any part of the following which is defective in material or workmanship (not neglect
to recommended use and service) with a “pro-rated” charge for parts only (not labor)
during the stated time period from date of purchase to the original retail customer:
IV.
COMMERCIAL USE: Coverage as in paragraph III.A.1. ONLY, except warranty coverage is for (90) days
for parts and labor to the original commercial retail customer.
V.
Repairs eligible for labor warranty must be made by Meyer Mfg. Corp. or an authorized Meyer dealership.
The original retail customer is responsible for any service call and/or transportation of the Super Spreader
to the dealership or factory for warranty service.
VI.
Except as stated above, Meyer Mfg. Corp. shall not be liable for injuries or damages of any kind or nature,
direct, consequential, or contingent, to persons or property. This warranty does not extend to loss of crop
or for any other reasons.
VII.
No person is authorized to give any other warranties or to assume any other obligation on Meyer Mfg.
Corp.’s. behalf unless made or assumed in writing by Meyer Mfg. Corp. This warranty is the sole and
exclusive warranty which is applicable in connection with the manufacture and sale of this product and
Meyer Mfg. Corp.’s responsibility is limited accordingly.
Purchased Product Warranty:
This warranty does not apply to component parts not manufactured by Meyer such as but not limited to wheels,
tires, tubes, PTO shafts, clutches, hydraulic cylinders, scales, etc.
After a period of (1) year, the spreader tank body is warranted against rust
through for an additional period of (6) years. (Pro-Rated Parts Only). Parts
included, front and rear end panels, side panels, and auger trough.
Seven (7) Years:
Содержание V-FORCE 7400 Series
