Free Plowing).
23. Meyer M-1 Hydraulic Fluid Part No. 15134 may need to be added to
reservoir and bleed the Angle Cylinders, proceed as follows:
a. Remove Fill Plug from reservoir to add fluid during charging.
b. Operate the Angle cylinders (2) until they are filled with Meyer M-1
Hydraulic Fluid and are not spongy.
c. Top off the unit to the fill line on the reservoir with Meyer M-1 Hydraulic Fluid.
NOTE: Proper fluid level is to the fill line on the reservoir for the V-71.
(S) terminal white wire
(I) terminal black wire w/white stripe
15059 Diode packed in Controller box
20. Run Universal Truck Side Harness (32) through a hole in grille and into
the engine compartment. Sandwich vehicle grill between Plug Bracket(8)
and Plate (9) using Bolt H 5/16-18 x 3” (13), 5/16 Lockwasher (11) and
5/16-18 Finish nut (12). Secure Universal Truck Side Harness (32) to Plug
Bracket (8) using Bolt H 5/16-18 x 1” (10), 5/16 Lockwasher (11) and 5/16-
18 Finish nut (12).
Secure Universal Truck Side Harness (32) from any hot /
moving parts with tie wraps as needed.
21. Drill a 1-1/4” Diameter Hole thru firewall and extend the harness into the
cab of the vehicle. Fused lead from Universal Truck Side Harness (32) must
be attached to terminal in fuse panel that is activated only when the igni
tion key is “on.”
22. Install Motor Solenoid (30) to metal surface in engine compartment using
Self Tapping Screws (24). (Solenoid must be grounded to operate). Attach
Red Power Cable (32) to a large terminal on Motor Solenoid (30). Attach
Black Ground Cable (32) to negative (-) terminal of battery. Attach Red
Power Cable (1) to positive (+) terminal of battery and remaining large
terminal on Motor Solenoid (30). Attach small white wire from harness
(32) to small terminal (S) on Motor Solenoid (30). Attach small Black/white
stripe wire from harness (32) to small terminal (I)(ground) on Motor Sole
noid (30) Attach Blue wire to a reverse signal on the vehicle. The blue wire
is sensing when the vehicle is in reverse in order to operate HFP (Hands
V-71 Fill level line
V-71 Fill Plug
(6)
Vehicle Side Wiring Diagram
32
1
Optional
Controller
30
24
8
9
10
13
11
12
33
Keyed Ignition (Blue)
Light Module "C" Harness
Light Module "B" Harness (Orange)
Red
Red
Black
White
Blue Wire
Light Module "C" Harness
Reverse
Signal
Black/White
Stripe
11
12
