MEWOI MEWOI1310B, Руководство пользователя, Страница: 11 / 16

7
5.3.8.
——“no- -”Dynamic display: not
received signal
6. Operation Method
Before usage, carefully check whether all parts of the meter are damaged. Only
when there is no damage can be used
According to manual instructions to install the battery
6.1. Detector Operation
6.1.1. Power On/Off
Press POWER button to power on, indication light up, enter into normal test mode. 15
minutes after power on, the meter will power off automatic without any operation.
6.1.2. General Test
Extremely dangerous! The operator must strictly follow the safety rules, otherwise
there would be danger of electric shock, causing personal injury or injury accident.
Dangerous! It is strictly forbidden to use this meter to test bare wires or busbars with
voltage over 110kV, otherwise there would be danger of electric shock, causing
personal injury or injury accident.
For high voltage test, the insulation rod must be connected and fully stretched. Hold
the end of the sheath of the insulation rod and use.
Must connect the meter with the special insulation rod
After normal boot up, Push the meter close to the tested wire with insulation rod, as shown
in Figure A , place the wire at the center of the bottom of the u-type clamp and as close as
possible to ensure the accuracy of the measurement as shown in Figure B . Pull back can
remove the meter from the tested wire, as shown in Figure C .