02/02
7-28-B
NORDBERG LT105/105S INSTRUCTION MANUAL
7-9
CHAPTER 7 - CRUSHING
Starting the crushing process
Before starting the crushing process, always make
sure that the crusher cavity is empty. If there is
material on the cavity, clear the cavity as instructed
in chapter 7.8.
When the crushing process has started, the RPM
speed of the diesel engine cannot be adjusted by the
operator before the crushing process has been
stopped again.
Initiate the crushing process by pressing “Process
ON” -button (ref 4.1 and 4.2)
NOTE:
When starting the crushing process, the
automatic control function takes care of starting the
devices, delays, monitoring any possible problems
and adjusting the RPM level of the diesel engine.
The initiation of the crushing process takes about
one minute after the process button has been
pressed.
–
Connect the water supply (if needed).
–
Turn on the lights if required.
Stop the crushing process by pressing the "Process
OFF” -button.
NOTE:
When stopping the crushing process, the
automatic control function takes care of turning off
the equipment, delays, monitoring any possible
problems and adjusting the RPM level of the diesel
engine. The termination of the crushing process
takes approximately 1 minute.
1. Process options eg. side conveyor, magnet
separator or hydraulic PTO must be selected before
the process start. Process options are editable
during the process.
2. You can stop the feeder and crusher in order to
safely remove uncrushable objects from the feeder.
Crusher and feeder can be restarted from the
service platform.
Load some material into the feed hopper while the
vibrating chute is running. For further instructions,
refer to Chapter 7.6 "Feed control".
When loading with the help of a wheel loader, the
feed hopper must be almost empty before any moer
material can be loaded into it. When loading with
the help of an excavator, more than one bucketful
can be loaded in to the hopper at a time.
Refer to the Crusher Instruction Manual for further
information on the crushing process.
In case of emergency press "Emergency
stop"-button to stop the LT105.
Do not attempt to crush stones that are too large to
fit inside the cavity. Having to reposition rocks
wastes time, reduces capacity, and imposes
unnecessary loads on the crusher.
You can stop the feeder and crusher in order to
safely remove uncrushable objects from the feeder.
Both the crusher and the feeder can be restarted
from the remote control box located in the service
platform.
https://tractormanualz.com/
Содержание NORDBERG LT105
