metrotek ETS-1000, Руководство по эксплуатации

Страница: 92 / 110

92 Remote control
Bits per second
57600
Data bits
8
Parity None
Stop bits
1
Flow control
None
• click OK , and HyperTerminal utility will attempt to connect to
ETS-1000 ; to check the connection, type
AT
command — the de-
vice should respond with
OK
.
When successfully connected, user can manage the analyzer using com-
mands described in Appendix B.
6.1.2 Updating analyzer software
Attention! False actions during the software update can lead to
the device part-malfunctioning which can be repaired in the service-
center only.
The latest versions of the ETS-1000 software are available for downloading
at
http://www.metrotek.spb.ru
site. Current software versions are shown
in the Information menu ( ETS-1000 Settings ⇒ Information ).
The order of update procedures for FPGA microcode and MCU program
does not matter. In addition, only one of those can be updated if there is no
new version for another one.
6.1.2.1 Updating FPGA
1. Connect the ETS-1000 to PC via USB (see section 6.1.1).
Check the connection using
AT
command.
2. Type in
ATR
command.
Select either system FPGA or expansion FPGA .
In the Transfer ⇒ Send File menu of HyperTerminal utility, specify
the path to FPGA microcode file (with .rpd extension) in the Filename
window and select the
Xmodem
in the Protocol window. Click Send .
Estimated duration of the update procedure is 1 minute for the system
FPGA and 4 minutes for the Expansion FPGA. If the data previous-
ly displayed on the screen has been restored, the update procedure is
completed successfully.
6.1.2.2 Updating MCU program
1. Connect the ETS-1000 to PC via USB (see section 6.1.1).
Check the connection using AT command.
ETS-1000. Operations manual