metrotek ETS-1000, Руководство по эксплуатации

Страница: 31 / 110

5.5 RFC 2544. Test parameters setup 31
•
Rates — switched to Rates menu.
Figure 5.16. Rates menu
• Rate source — if you press button ( Throughput ), Latency test
will be performed with rates values that are a result of Throughput test.
If you press
button ( Manually ), Latency test will be performed with
physical rates value defined by user in percent ( ), in kbps ( ) or
in Mbps ( ).
5.5.3 Frame loss test settings
Figure 5.17. Configuring test settings
•
Enabled — enable/disable frameloss analysis.
•
Trial, s — time of the trial performing (within 1–2886 s range) for each
of the specified frame sizes.
•
Steps qty, % — number of rate changing steps within 1–10 % range.
•
Start rate & Stop rate fields will determine range of physical rates
value (specified in percent ( ), in kbps ( ) or in Mbps ( )).
ETS-1000. Operations manual