Metronix 9200-4104-2000, Инструкция по монтажу

Страница: 71 / 95

6 Technical data
6.5 BL 4100-M / BL 4100-D:
Motor connector [X6]
Performance data
Supply voltage 230 VAC [± 10 %], 50 Hz, f
PWM
= 5 kHz, f
el
> 2 Hz,
T
Ambient
= 30°C
Characteristic BL 4104-D BL 4104-M
Nominal output power 800 W 700 W
Maximum output power for 2 s 2400 W 2400 W
Nominal output current 4 A
eff
3 A
eff
Max. output current for 2 s 12 A
eff
12 A
eff
Power loss/efficiency
*)
4 % / 96 %
*)
As a guide value for the cooling measures.
Current derating
The BL 4100-M / BL 4100-D series servo drives have a current derating during nominal
operation. The rated current and the duration of the maximum permissible peak current of
the servo drive depend on several factors. These factors are:
l
Output current level: The higher the output current is, the shorter the permissible
time will be.
l
Clock frequency of the power output stage: The higher the clock frequency is, the
shorter the permissible time will be.
The current derating begins as of a PWM frequency of 10 kHz (f
PWM
) and is linear
between the reference values that are stated in the following table:
PWM frequency f
PWM
*)
BL 4104-M / BL 4104-D
I
nominal
I
max
10 kHz 4 A 12 A
16 kHz 3 A 9 A
*)
The PWM frequency is the reciprocal of half of the current controller cycle time t
i
. The
variable cycle times enable particularly high dynamics combined with reduced power
data.
Motor cable requirements
Characteristic Value
Cable length
l
≤
2 m
See section 5.1 Notes concerning the safe and EMC-
compliant installation on page 26
Cable capacity C‘
≤
160 pF/m
of one phase against shield or between two lines
Mounting Instructions BL 4000-M and BL 4000-D Page 71 of 95