FREESAT HD SOFTWARE UPGRADE
These instructions will assist you in downloading the software upgrade to the Freesat HD receiver.
This information is also available on page 14 of the Instruction manual.
1. Insert a USB stick into the USB slot situated at the back of the receiver between the power
cable and the HDMI cable. (If the stick is too wide, remove the HDMI cable and connect the
receiver using a scart lead – please note if using the scart lead you will need to change the TV
source to AV1 or 2).
2. Select
MENU
SYSTEM
INFORMATION
3. Select
USB UPGRADE
SELECT SLOT
SELECT USB
- Press OK
4. Select
DRIVE
and after a few seconds Line A will display “Disk 1” – Press OK
5. Select the Highlighted file “
zdx620_freesat_v083.zim
” – Press OK
6. Wait until the reading of the file is completed and when the message “Do you want to update”
appears, Select YES to perform the software upgrade.
7. Please wait until the Programming Flash process is completed (do not switch off the power or
remove the USB device during this process).
8. Reset to default in the
SET DEFAULTS MENU
– Select
YES
to restore to factory default with
all current settings and data eliminated or Select
NO
to keep the current data settings.
The USB stick can now be safely removed from the receiver. Once removed turn the receiver onto
standby and unplug the power cord before reinserting to reboot the receiver.
