Metrohm 774, Инструкция по эксплуатации, Страница: 133 / 168

5.11 Description of the remote control commands
774 Oven Sample Processor, Instructions for use
127
.Heater.S Stop: Switching off of the heater
.E Error: Message with error number (see page 104)
Format of AutoInfo messages:
(space)!device name"AutoInfo node"
Example: !Oven1".G"
5.11.4.10 S etup .P owerOn $G
Simulation of "power on". The method last used is ready for operation.
5.11.4.11 S etup .In itialize $G
S etup .In itialize .S elect param , config, setup,
assembly, all
Setting of default values for the following branches:
param:
Method parameters (sets empty method '
∗∗∗∗∗∗∗∗
')
config: Configuration, branch &Config
setup: Branch &Setup
assembly: Branch &Assembly
all: All values of the entire tree.
Initialization is triggered with &Setup.Initialize $G.
5.11.4.12 S etup .R amInit $G
Initialization of the entire working memory. All parameters will be set to de-
fault; error messages will be deleted.
5.11.4.13 S etup .Ins trNo .V alue 8 ASCII characters
Device number. Essential for service purposes. The device number must
not be altered.
5.11.5 &UserMeth …
5.11.5.1 U serMeth .F reeMemory read only
$Q queries the size of free memory (in bytes), available for user methods.
5.11.5.2 U serMeth .R ecall $G
U serMeth .R ecall .N ame 8 ASCII characters
U serMeth .S tore $G
U serMeth .S tore .N ame 8 ASCII characters
U serMeth .D elete $G
U serMeth .D elete .N ame 8 ASCII characters
U serMeth .DelA ll $G
Management of the internal method memory: loading, storing and deletion
of methods. The execution of a function is performed by sending $G to the
corresponding node, after entering the method name. Do not use preced-
ing or succeeding blanks in method names!
.DelAll;$G deletes all method in the user memory.
5.11.5.3 U serMeth .L ist .1.N ame read only
U serMeth .L ist .B ytes read only
for each method
List of all method in the user method memory including method name and
file size in bytes.