Metrohm 2.850.2230, Руководство пользователя, Страница: 83 / 150

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Installation
850 Professional IC–Anion – MSM-HC – MCS – LP Gradient
￭￭￭￭￭￭￭￭
73
Connecting and rinsing the separation column
1 Connecting the separation column
CAUTION
When using the columns, always ensure that these are correctly
inserted corresponding to the flow direction indicated.
￭
Remove stoppers from the separation column.
￭
Connect the lower end of the separation column with a
6.2744.070 short PEEK pressure screw to the outlet capillary of
the guard column (if used), or to the column input capillary .
2 Rinsing the separation column
￭
Place beaker under the outlet end of the separation column.
￭
Set the flow rate of the high pressure pump to the value suitable
for the separation column selected.
￭
Start the high pressure pump and rinse the separation column
approx. 10 minutes with eluent.
￭
Switch off the high pressure pump again.
3 Mounting the separation column
￭
Hang separation column with chip into the column holder.
NOTE
The iColumns are equipped with a chip on which their operating data is
saved. The chip has to be hooked into the chip holder provided for this
so that the column recognition can function.