Metrodata FM4900, Руководство пользователя

Страница: 29 / 68

INSTALLING & SETTING-UP
21 76-02-011F
Pressing the space bar will cause the next available value to be displayed opposite the
option. When the required value is displayed, simply press the
<enter> key to accept the
value or press <escape> to leave the existing value unchanged.This process is known as
toggling.
Note that if you use a PC with the Windows Hyperterm terminal emulator set to VT100/220,
click on
View/Font and activate MS Linedraw to achieve best picture quality.
5. 4 Default settings
The default settings for the terminal connected to the management port are given in the table
below.
The terminal must be set to the FM4900’s default values after performing a cold start. Once
this is done, the FM4900’s V.24 settings can be changed using the
V.24 SET-UP menu,
which is accessed from the MAIN SET-UP menu described in the next section.
The default terminal is a Teletype (TTY), but the vast majority of users will employ a VT100/
220 or an ANSI terminal either directly or on a PC via a terminal emulator. The TTY output
screens do not have graphic capability, and are therefore not so easy to read when setting
up the system.
After a making change in the FM4900’s stored terminal set-up (with the terminal on default
settings), select
LOAD NEW CONFIG on the menu screen. The physical terminal must then
be re-set to correspond to the new values stored in the unit.
Figure 5. 7 V.24 Terminal set-up defaults and options
V.24 Item Defaults Options
Terminal type TTY TTY, VT100/220, ANSI
Baud rate 9600 2400, 4800, 9600, 19200
Parity None Odd, Even
Data bits 8 7 or 8
Stop bits 1 1 or 2
Flow control Xon/Xoff